MUSE Laser Cutter

Machine Status: No longer in the 有料盒子视频 Makerspace (archived for reference)

Read the manual for the RetinaEngrave before hand. You will be using the RetinaEngrave app for your design.

Preparing a file:

  1. Open RetinaEngrave with the URL

  2. Either create your design using the tools in the workspace, or import a file* using the "file->load project from file" option

              *For vectors, import an svg file. For rasters, any image file should work.

  3. NOTE: When importing an svg file into re3, make sure that all lines are joined. This can be done using Adobe Illustrator or Inkscape.

  4. Double check that your design uses the appropriate settings and parameters.

Setup Instructions:

  1. Turn on both the Laser and Water Pump (check that there is water in the tank)

  2. Check that machine is clear of debris.

  3. On computer: type 鈥渇sl.local/designer鈥 into the URL to open up RetinaEngrave

  4. Upload your file into RetinaEngrave using the "file->load project from file" option

Focusing the Laser:

Each time a new type of material is used, you need to use the Focus Puck to set the Z-Axis height of the laser. To focus the laser:

  1. Loosen set screw on the left side of the laser head.

  2. Place the Focus Puck between the material and Laser Head Nozzle

  3. Tighten the set screw until it is finger tight.

  4. Remove Focus Puck

Running a Cut Job

  1. Make sure that all of your parameters are correct.

  2. Place the material that you would like to cut/engrave onto the material bed.

  3. Click the "run perimeter" button on Retina Engrave (not on the cutter's screen).

  4. Adjust your material/file accordingly.

  5. When you are ready, click "run job."